Front ABS Wheel Speed Sensor Pair for Nissan Sentra 2007-2012 | Left 47911-ZT00A + Right 47910-ZT00A | Set of 2 with Harness

Replace both front sensors in one job — and save. This set contains two different sensors, because the Sentra uses a different part on each side of the front axle: one front left (driver side, 47911-ZT00A) and one front right (passenger side, 47910-ZT00A). Both are direct-fit replacements with the factory 2-pin connector and full harness — no splicing, no programming.

What you get: 1 × front left ABS wheel speed sensor (47911-ZT00A) + 1 × front right ABS wheel speed sensor (47910-ZT00A), each with its wiring harness.

Fitment: 2007–2012 Nissan Sentra with the 2.0L (MR20DE) and 2.5L (QR25DE) engines, including Base, S, SE-R and Spec V trims. Front axle only — the rear uses different sensors, so message us your VIN if you're unsure.

Why Replace Both Sides

• Both front sensors see the same road conditions, salt and heat — if one has failed, the other is usually not far behind
• Avoids the "ABS light came back a month later" second repair and a second trip to the jack
• Costs less than buying the two sensors separately
• One jack-up, one set of tools, both front wheels done

Replaces These Part Numbers

Nissan OE

• Left: 47911-ZT00A  ·  47911-ET000
• Right: 47910-ZT00A  ·  47910-ET000

Aftermarket Cross Reference

• Left: ALS616  ·  5S8479 / 5S12289  ·  SU13707  ·  084-4382
• Right: ALS628  ·  5S8478 / 5S12288  ·  SU13706  ·  084-4383

Vehicle Fitment

Front axle only. Rear sensors (47900 / 47901) are a different part and are not included. Message us your VIN if you'd like us to verify fitment.

Key Features

• Two sensors — the correct left and right parts for the front axle, in one order
• Direct OE replacement, factory-style 2-pin connectors, plug and play
• Each sensor comes with its wiring harness (the most common failure point on the original part)
• Active Hall-effect design for a clean signal at all speeds
• Sealed against road salt, mud, water and brake heat
• 100% function tested before shipping

Symptoms This Set Fixes

• ABS warning light on the dash
• Traction control / VDC light on at the same time
• Front wheel speed sensor fault codes
• Speedometer jumping, inaccurate or dropping out
• ABS activating at low speed or failing to activate when needed

Installation (about 45 minutes per side)

1. Loosen the lug nuts, raise and support the front of the car, remove the wheel.
2. Unplug the sensor connector and remove the mounting bolt.
3. Pull the old sensor out and clean the mounting hole and hub surface.
4. Install the new sensor, routing the harness exactly like the original.
5. Reconnect, refit the wheel, torque the lug nuts to factory spec.
6. Repeat on the other side, then drive a short distance — the ABS light should clear on its own.

What's in the Box

• 1 × Front Left ABS Wheel Speed Sensor (47911-ZT00A) with harness
• 1 × Front Right ABS Wheel Speed Sensor (47910-ZT00A) with harness

Warranty

1-year limited warranty against manufacturing defects on both sensors. Contact us for a replacement if either sensor fails within the warranty period.

FAQ

Are these two identical sensors?
No — on the Sentra the front left and front right use different part numbers, so this set contains one of each: 47911-ZT00A for the driver side and 47910-ZT00A for the passenger side.

Can I buy just one side?
Yes — see our single front left sensor listing. The right side is sold separately.

Do these fit the rear axle?
No. The rear uses different sensors (47900 / 47901). This set is for the front only.

Will it fit my 2013 or newer Sentra?
No — this set covers the 2007–2012 Sentra. Message us your VIN and we'll confirm the right part.

Do I need a scan tool?
No. The ABS module re-learns the signal on the next drive.